LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2002 >> S55 >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Entertainment, Lighting & Navigation -- Retrofitting & Conversion -- 215 & 220 Chassis >> Retrofitting & Conversion >> Retrofit cell phone - AN82.70-P-0002 >> Retrofit cell phone - AN82.70-P-0002MA >> Notes

Retrofit cell phone - AN82.70-P-0002MA: Notes

MODEL 220 up to 30.6.00 with CODE (750a) MB radio Audio 30 RDS 

MODEL 220 up to 30.6.00 with CODE (750a) MB radio Audio 30 RDS with CODE (810) Sound system with CODE (819) 6-disk CD changer 

MODEL 220 up to 30.6.00 with CODE (352a) COMAND operating and display system 

MODEL 220 up to 30.6.00 with CODE (352a) COMAND operating and display system with CODE (810) Sound system with CODE (819) 6-disk CD changer 

Fig 1: Identifying Cell Phone Components - Model 220 Up To 30.6.00
G04852686
IMPORTANT Notes on fiber optic   AH82.70-P-0001-02A
REMOVING Removal     
1 Remove rear passenger compartment floor covering    
REFER TO TESTING & REPAIR     AR68.20-P-4800M
2.1 Remove radio    
REFER TO TESTING & REPAIR     AR82.60-P-7502I
2.2 Remove/install operating, display and control module with COMAND (code 352a) operating and display system  
REFER TO TESTING & REPAIR     AR82.85-P-7472I
3 Connect quiescent current retention device   *WH58.30-Z-1012-09A 
DANGER Risk of explosion  from explosive gas. Risk of poisoning and caustic burns  from swallowing battery electrolyte. Risk of injury  through burns to skin and eyes from battery acid or when handling damaged leadacid batteries No fire, sparks, naked flames or smoking.
Wear acid-protective gloves, clothing and eye protection. Pour battery electrolyte only into suitable and appropriately marked containers.
AS54.10-Z-0001-01A
4 Disconnect ground cable of battery    
REFER TO TESTING & REPAIR     AR54.10-P-0003I
NOTES Battery notes All types. AH54.10-P-0001-01A
5.1 Open right wiring duct    
5.2 Open left wiring duct with sound system (code 810)  
6 Remove rear backrest    
REFER TO TESTING & REPAIR     AR91.12-P-1620MA
REFER TO TESTING & REPAIR   with single seats (code 401). AR91.12-P-1620M
7.1 Remove seat adjustment mechanism on rear seat with single seats (code 401).  
REFER TO TESTING & REPAIR     AR91.12-P-1520M
8 Remove coverings in trunk    
REFER TO TESTING & REPAIR     AR68.30-P-4600M
9 Remove rear wall in trunk    
10 Remove/install SAM with fuse and relay box, left front IMPORTANT Do not remove completely, only do so far enough to enable an additional cable to be pulled through from driver's footwell and connected to fuse and relay box.  
REFER TO TESTING & REPAIR     AR54.21-P-1260I
11 Remove molding on rear window    
REFER TO TESTING & REPAIR     AR67.20-P-2200M
INSTALLING Install     
12 Install optical waveguide module    
REFER TO TESTING & REPAIR     AR82.70-P-0004-01A
13.1 Retrofit fiber optic wiring harness except code 810, code 819. AN82.70-P-0002-01MA 
REFER TO TESTING & REPAIR Cover optical waveguide NOTESDo not kink or stretch D2B fiber optic.  AR82.95-P-0005-01A
    IMPORTANT Install covers on fiber-optic coupling and equipment connector.  
13.2 Retrofit fiber optic wiring harness With code 810, code 819 AN82.70-P-0002-01MB 
REFER TO TESTING & REPAIR Cover optical waveguide NOTESDo not kink or stretch D2B fiber optic.  AR82.95-P-0005-01A
    IMPORTANT Install covers on fiber-optic coupling and equipment connector.  
14 Retrofit telephone cable harness IMPORTANT Voltage supply wiring harness AN82.70-P-0002-03MA 
15 Retrofit interface   AZ82.70-P-0001-07IA
16 Retrofit CTEL/GPS antenna   AZ82.70-P-0001-08IA
17 Retrofit handset IMPORTANT Portable CTEL bracket AZ82.70-P-0001-09IB
18 Retrofit handsfree microphone   AN82.70-P-8969-04MA 
19 Installation proceeds in reverse order IMPORTANT Steps 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11.  
20 Perform startup and function check IMPORTANT Carry out control unit coding (CTEL) using STAR diagnosis  
21 when scope of equipment changes reenter code or designation of corresponding special equipment on vehicle card    
COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1012-09A Quiescent current retention unit
PARTS ORDERING NOTES

Part no. Designation Quantity
Design Group 82 (see EPC) Mobile phone Nokia 3110 1
Design Group 82 (see EPC) Battery unit (rechargeable battery for mobile phone) 1
Design Group 82 (see EPC) Assy. mobile phone mount 3110 1
Design Group 82 (see EPC) Adapter plate for assy. mount LHD 1
Design Group 82 (see EPC) Adapter plate for assy. mount RHD 1
Design Group 82 (see EPC) Cable, voltage supply in center armrest 1
Design Group 82 (see EPC) RF cable in center armrest 1
Design Group 82 (see EPC) Cable harness for vehicles with long wheel base 1
A220 540 73 08 Cable harness for vehicles with short wheel base 1
Design Group 54 (see EPC) Floor panel (if not fitted) 1
A140 990 02 50 Collared plate nut for fastening floor panel (if not fitted) 3
N 914 128 004 200 Self-tapping collared screw for fastening floor panel (if not fitted) 1
A220 820 67 26 Mobile phone control module (interface) 1
A001 990 21 36 PT screw for control module 2
A220 820 13 35 Handsfree system microphone 1
Design Group 69 (see EPC) Mirror cover plate (Color depending on interior equipment - 7D431A26AG691A36+equipment) 1
Design Group 82 (see EPC) CTEL antenna assembly 1
A000 995 04 14 Line fastener 1
A009 997 53 81 Grommet 1
Design Group 82 (see EPC) Adhesive pad 1
A006 989 39 71 4299 Scotch-Mount glass primer bonding agent  
  Cable harness/optical waveguide D2B differs according to equipment, which was fitted before installation  
  No code 810 or code 819 installed in the vehicle   
Design Group 82 (see EPC) Cable harness D2B 1
  Code 810 or code 819 installed in the vehicle/code 810 and code 819 installed in the vehicle   
Design Group 82 (see EPC) Optical waveguide module (order with length 7575 mm) 1
Design Group 82 (see EPC) Fiber optic cable module (order with length specification 3285 mm) 1
Design Group 82 (see EPC) D2B clutch housing 1
Design Group 82 (see EPC) D2B clutch housing 1