Remove/install front center assembly suspension on rear axle carrier - AR35.10-P-0051M
MODELS 215.374/ 376/ 379
MODELS 220.074 /174 /176 /179
Fig 1: Identifying Front Center Assembly Suspension On Rear Axle Carrier Remove/Install Components - Model 215.374/376
| Remove/Install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the parts will be affected | |||
| Notes on self-locking nuts and bolts | All models | AH00.00-N-0001-01A | |
| 1.1 | Remove exhaust system as of flange connection | Engine 275.950 | AR49.10-P-7280M |
| Refer to Removing exhaust system complete: ↓ |
|||
| Engine 113 | AR49.10-P-7000AA | ||
| 1.2 | Remove rear muffler | Engine 275.980 in model 215.379, 220.179 | AR49.10-P-4951IM |
| 2 | Support rear axle center assembly (1) | Figure | |
| 3 | Detach front center assembly suspension (7) from rear axle center assembly (1); for this purpose, remove bolted connection (8) | *BA35.10-P-1001-04A | |
| 4 | Remove bolted connection (10) and front center assembly mount (7) | *BA35.10-P-1003-04A | |
| 5 | Install in the reverse order |
| Number | Designation | Model 215.374/376/379 | Model 220.074/174/176/179 | ||
|---|---|---|---|---|---|
| BA35.10-P-1001-04A | Self-locking nut, front center assembly mount to rear axle carrier | Nm | 120 | 120 | |
| BA35.10-P-1003-04A | Self-locking bolt, rear axle center assembly to front center assembly mount | 1st stage | Nm | 100 | 100 |
| 2nd stage | ∠° | 180 | 180 | ||