Eliminate line leakage at valve unit - SM32.50-P-0004A

MODEL 215

MODEL 220 with CODE (487a) Active body control (ABC)

MODEL 230 with CODE (487a) Active body control (ABC)

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Range	Op. no.	Operation text	Time	Acc. no.	Code
P	327490	Active Body Control (ABC)- check system for leaks	Time prescribed by foreperson	-	-

MODIFICATION NOTES

5.3.03

Value changed from 50 Nm to 45 Nm

Value in series 1001, 1002,1003, 1012 line 1 and 2, 1013 modified for model 230

	Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid.	Release the pressure in the hydraulic system completely before starting any work on the system. Wear protective clothing and safety glasses.	AS00.00-Z-0013-01A
1	Loosen leaky line, center and tighten without tension to 50...55 Nm	Wait for pressure relief in ABS system. Pressure is relieved 10 minutes after engine is shut down so that the ABC high pressure line can be opened. It is only possible to ensure that the line connections are properly tightened when they are positioned tension-free with particular care (tighten nuts as far as possible without using tool) and then tighten to specified torque.
		Union nut, line to pressure reservoir	*BA32.50-P-1001-01A
		Union nut, line to front/rear axle valve unit	*BA32.50-P-1002-01A
		Union nut, line to distributor	*BA32.50-P-1003-01A
		Union nut, line to pressure supply valve unit	*BA32.50-P-1012-01A
2	Check system for leakage	For this purpose: Clean leaky point. Spray line/component with leak detection spray. Connect STAR DIAGNOSIS. Select menu item "Actuation" in the ABC system and allow the vehicle to run for at least 10 min in the "Rodeo" program (whereby the system heats up to reach operating temperature). Perform visual check. If the system is still leaky: ↓ Remove/install/replace leaky lines. Check system for leakage For this purpose: Clean leaky point. Spray line/component with leak detection spray. Allow vehicle to run for at least 5 min in the "Rodeo" program. Perform visual check. If the system is still leaky: ↓ Remove/install/replace the corresponding counterpiece for the line terminal (e. g. valve block, T-piece) Check system for leakage For this purpose: Clean leaky point. Spray line/component with leak detection spray. Allow vehicle to run in the "Rodeo" program for a further 5 minutes. Perform visual check.

ACTIVE BODY CONTROL SUSPENSION

Number	Designation			Model 215	Model 220	Model 230
BA32.50-P-1001-01A	Union nut, line to pressure reservoir		NM	50	50	45
BA32.50-P-1002-01A	Union nut, line to front/rear axle valve unit		NM	50	50	45
BA32.50-P-1003-01A	Union nut, line to distributor		NM	50	50	45
BA32.50-P-1012-01A	Union nut, line to pressure supply valve unit	M14	NM	50	50	45
BA32.50-P-1012-01A	Union nut, line to pressure supply valve unit	M16	NM	50	50	45