Removing and installing crank window in front door - AR72.10-P-1900N

MODEL 215 

Fig 1: Identifying Crank Window In Front Door Remove/Install Components (1 Of 2)

Fig 2: Identifying Crank Window In Front Door Remove/Install Components (2 Of 2)

	Removal, installation
	Injury hazard  from unsecured windows pinching hands.	Secure windows against falling down.	AS67.00-Z-0002-01A
1	Remove door paneling in front door		AR72.10-P-1000N
2	Disconnect left/right door loudspeaker connector (X1/6, X1/7)
3	Unscrew screws (10) and remove woofer speakers (H4/1h2, H4/2h2)		Figure
4	Pull off insulating mat in bottom area of inner door panel
5	Remove inner sealing rail		AR72.10-P-1600E
6	Remove molding strip with sealing rail on outside		AR72.10-P-1700N
7	Open crank window (1) until mounting screws (4) are accessible through the installation openings in the inner door panel (3)
8	Unscrew screws (4)		*BA72.10-P-1010-01E
			Figure
		Installation:  When mounting screws (4):↓
		Adjust crank window on front door	AR72.10-P-1950N
9	Remove crank window (1) from window shaft	Installation:  Clean crank window (1) with MB motor vehicle glass cleaning agent	*BR00.45-Z-1007-04A
10	Install in opposite order

FRONT DOOR TIGHTENING TORQUE

Number	Designation		Model 215
BA72.10-P-1010-01E	Screw for crank window in front door on window lift mechanism	Nm	9

Fig 3: Identifying Torx Bit Set (000 589 01 10 00)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1007-04A	Cleaner	A 001 986 38 71