Remove/install front door crank window - AR72.10-P-1900M

MODEL 220 

Fig 1: Identifying Front Door Crank Window Remove/Install Components(1 Of 2)

Fig 2: Identifying Front Door Crank Window Remove/Install Components(2 Of 2)

	Remove, Install
1	Remove/install front door liner		AR72.10-P-1000M
2	Remove insulating mat in bottom area of inner door panel	Installation:  Before installing insulating mat, check crank window (1) for easy motion
3	Remove inner sealing rail		AR72.10-P-1600E
4	Remove trim strip with outer sealing rail		AR72.10-P-1700E
5	Unscrew bolt (2)	Removal:  Open crank window (1) until assembly openings (5) of inner door panel and mounting screws (2) are accessible Installation:  When installing screws (2):↓
		Adjust crank window (1) for front door	AR72.10-P-1950M
6	Move crank window (1) out of mounts on power window (4)	Thereby move crank window (1) upward until mounting lugs for crank window (1) slide out of power window mounts (4)
7	Remove crank window (1) out of door shaft.	For this purpose tilt crank window (1) toward front and pull out of front window guide rail downward and turn until rear edge of crank window (1) can be removed from door shaft Installation:
		Clean crank window (1) with MB auto glass cleaner	*BR00.45-Z-1007-04A
8	Install in the reverse order

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1007-04A	Cleaner	A 001 986 38 71