Carry out conditions and tests for chassis alignment - AR40.20-P-0260SX

MODEL 169, 171, 203, 204, 209, 211, 215, 216, 219, 220, 230, 245 

MODEL 221 except CODE (Z07) Top protection 

	Checking
1	Check condition of vehicle	All the vehicle parts must be installed for the chassis alignment and the vehicle should be completed so that it is operational The vehicle specified values are provided through the measuring system by means of actual values determined. The values are transferred to the measuring system after the vehicle level measurement. As a result the corresponding vehicle level is taken into account during the chassis alignment and the vehicle must no longer be loaded or refueled.
2	Print out form for wheel alignment check	If necessary, when an optical chassis alignment is performed.
	Wheel Alignment Form		OF40.20-P-3000-01B
3	Check tire condition for wear pattern, tread depth and damage	Visual inspection.
4	Check rim condition for damage	Visual inspection.
5	Check tire inflation pressure and correct if necessary	See tire inflation pressure chart inside the fuel filler flap.
6	Check vehicle underside for damage, corrosion of chassis parts and supporting body parts, leaks from major assemblies and lines	Visual inspection.
7	Raise front axle and check wheel bearing play without dial indicator
8	Checking condition of steering mechanism	Tie rods, tie rod joints and steering coupling.
	Check track rod and drag link linkage for play, check rubber boots	Models 169, 245	AP46.00-P-4653AK
		Model 171	AP46.00-P-4653V
		Models 203, 209, 211, 215, 220, 230	AP46.00-P-4653F
		Model 204	AP46.00-P-4653CW
		Models 216, 221	AP46.00-P-4653SX
		Model 219	AP46.00-P-4653TX