Removal and installation of thrust arm - AR35.20-P-0113MB

MODELS 220.175 /178 with CODE (Z04) Light armoring with CODE (Z07) maximum protection

Fig 1: Identifying Thrust Arm Remove/Install Components - Model 220.175/178

G04845433

	Remove/install
	Lethal injuries are possible if vehicle slips off of lifting platform	Align vehicle between the four pillars of the hoist and position the four support plates at the hoist mounting points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Installation			Replace all self-locking nuts and bolts
1	Remove thrust arm (5) from wheel carrier and rear axle carrier
		Installation: The rear axle shaft must be horizontal when tightening the nuts.
		Torque strut to wheel carrier	*BA35.20-P-1002-05B
		Torque strut to rear axle carrier	*BA35.20-P-1001-05B
2	Install in the reverse order

TORQUE SPECIFICATION

TORQUE STRUT

Number	Designation			MODEL 220 with CODES Z04, Z07
BA35.20-P-1001-05B	Self-locking nut for thrust arm to rear axle carrier		Nm	120
BA35.20-P-1002-05B	Self-locking nut for thrust arm to wheel carrier	M16	Nm	230