Bolted connection between rear axle carrier front and rear rubber mounts and frame floor modified - BT35.10-P-0004-01I
MODELS 215.375 /378, 220.026 /028 /063 /065 /070 /075 /128 /165 /170 /175 /178 as of 9.10.00
As of October 2000 the bolted connection between the rear axle carrier front and rear rubber mounts and the frame floor has been modified.
The bolt head diameter (d) has been increased. The bolt flange diameter has also been increased from 24 mm (a) to 26 mm (b), meaning that the washer is not required.
The tightening torque of the previous bolted connection has also been modified. The value of 95 Nm no longer applies.
Please note modified tightening torque of previous bolted connection and tightening torque of new bolted connection. Otherwise crackling noise could occur at this bolted connection due to pushing and pulling stress.