LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2002 >> S430 >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Axle -- Testing & Repair -- 215 & 220 Chassis >> Testing & Repair >> Remove/install torque strut at front axle - AR33.15-P-0160 >> Remove/install torque strut at front axle - AR33.15-P-0160I >> Press the radius rod out of the stub axle assembly - AR33.15-P-0160-01I

Press the radius rod out of the stub axle assembly - AR33.15-P-0160-01I

TORQUE SPECIFICATION WHEEL LOCATION, HUB

Number Designation Model 211 except 211.08/09/ 28/29 Model 215 Model 220 except 220.08/18
BA33.20-P-1013-01A Self-locking nut, radius rod to steering knuckle 1st stage Nm 50 50 50
Stage 2 ∠° 60 60 60
TORQUE SPECIFICATION WHEEL LOCATION, HUB

Number Designation Model 230
BA33.20-P-1013-01A Self-locking nut, radius rod to steering knuckle 1st stage Nm 50
Stage 2 ∠° 60
Fig 1: Identifying Thrust Piece (140 589 00 63 00)
G04840732
Fig 2: Identifying Puller (220 589 00 33 00)
G04840733
Fig 3: Identifying Press (163 589 03 43 00)
G04840734
  1. Unscrew self-locking nut from radius rod coupling.
  2. SPECIAL TOOL Screw thrust washer (044a) onto the radius rod coupling.
  3. SPECIAL TOOL Apply the puller (035).
  4. SPECIAL TOOL Use the press (064) and press out the radius rod (18) from the stub axle (5) by turning the spindle (arrow)

    IMPORTANT Do not damage the rubber boot on the radius rod joint when pressing out.

    Shown on model 220 

    Fig 4: Identifying Thrust Washer, Puller, Press, Radius Rod And Stub Axle - Shown On Model 220
    G04840735
scientia non olet · About LEMON Manuals