Remove/install fire extinguishing system manual activation switch - AR86.10-P-0105MB

MODEL 220.1 /8 with CODE (Z04) Light armoring with CODE (Z07) Top protection with fire extinguishing system 

Fig 1: Identifying Fire Extinguishing System Manual Activation Switch Remove/Install Components

	Remove/Install
1	Ignition Off, detach transmitter key from the electronic ignition switch control unit
2	Remove fuses no. 54 and no. 58 from rear fuse and relay module	The rear fuse and relay module is located below the right rear seat See ↓
		Fuse assignment of rear fuse and relay box	GF54.15-P-1256-01MB
3	Remove cover on gearshift lever		AR68.20-P-2310M
4	Remove bolts (4)
5	Lift stowage shell (3) upward
6	Expose electrical connector (5) and electrical connector (6) and mark	The electrical connector (5) for the triggering button (1) has a single-color cable and the electrical connector (6) for the activation button (2) has a multiple-color cable. They should not be mixed up to prevent malfunction
7	Disconnect electrical connector (5) from triggering button (1) and electrical connector (6) from activation button (2)
8	Remove stowage shell (3) with fire extinguishing system manual activation switch (S62/23) from center console
9	Remove fire extinguishing system manual activation switch (S62/23) from stowage shell (3)
10	Install in the reverse order
11	Perform self-test for fire extinguishing system		AR86.10-P-0101-01MB