 |
Removing |
|
|
| 1 |
Remove trunk lining |
Rear wall paneling can remain in vehicle. |
AR68.30-P-4600M |
| 2 |
Disconnect PTS connector, rear bumper (X35/28) |
Code 220a. |
|
| 3 |
Disconnect emergency call system (TELEAID) backup antenna connector (X23/11) |
Code 347 Code 220a. |
|
| 4 |
Remove covers (9) over inner nuts (4) and remove nuts (4) |
|
|
| 5 |
Unscrew bolts (5) |
|
|
| 6 |
Unscrew nuts (14) |
|
|
| 7 |
Push fender liner (7) to the side and unscrew bolts (6) |
|
|
| 8 |
Remove bumper (1) |
|
|
| 9 |
Unscrew bolts (10) and remove bumper bracket (2) from bumper (1) |
|
|
 |
Installing |
|
|
| 10 |
Modify M-AMG bumper |
See installation instructions for accessories: ↓ |
|
| |
|
Retrofit M-AMG trim |
AZ88.00-P-0001K |
| 11 |
Fit bumper bracket (2) in bumper (1) and screw in bolts (10) |
|
|
| 12 |
Fit adjusting wedge (3) on threaded studs on bumper bracket (2) |
|
|
| 13 |
Install bumper (1), push bracket (11) into guides (8) on left and right |
|
|
| 14 |
Screw on nuts (4), (do not tighten) |
|
|
| 15 |
Adjust bumper (1) in longitudinal direction |
Move adjusting wedge (3) with adjusting pin (3a) until edge at bumper (13) is in alignment with the edge at the rear fender (12). |
|
| 16 |
Tighten nuts (4) and fit covers (9) |
 |
*BA88.20-P-1002-01A |
| 17 |
Screw in bolts (5) |
|
|
| 18 |
Screw on nuts (14) |
|
|
| 19 |
Screw in bolts (6) and install fender liner (7) |
|
|
| 20 |
Connect PTS connector, rear bumper (X35/28) |
Code 220a. |
|
| 21 |
Connect emergency call system (TELEAID) backup antenna connector (X23/11) |
Code 347. |
|
| 22 |
Install trunk lining |
|
AR68.30-P-4600M |