Stationary ventilation, function - GF83.70-G-2006A

WARNING: This page does not describe the selected car, but rather 22 other vehicles, including the 2015 Mercedes-Benz G550, 2014 Mercedes-Benz G550, 2013 Mercedes-Benz G550, 2012 Mercedes-Benz G550, and 2011 Mercedes-Benz G550. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 463 as of 1.6.94 with CODE (H12) Stationary heater

Function prerequisites

Vehicle heater set to "min" (microswitch S46/7 not actuated)
Vehicle blower set to stage "1"
Vehicle battery sufficiently charged
Stationary heater not in malfunction interlock mode

Function sequence

The stationary ventilation can be started and stopped by pressing the button "immediate heating/immediate ventilation" on the stationary heater timer (N34) or by pressing the switch on the associated RF remote control.

Moreover, the stationary ventilation can be programmed with the stationary heater timer (N34).

When stationary ventilation is started the heater actuates the stationary heater relay terminal 15/30 (K16) . This connects the blower motor (M2) for the vehicle to terminal 30. The vehicle blower starts running blowing air into the passenger compartment.

Stationary ventilation can be terminated by switching off, by malfunction shut off or after expiration of the maximum ventilation time of 60 min.

	Malfunction shut-off		GF83.70-G-3037A
	Stationary heater timer		GF83.70-G-4007A
	Radio frequency remote control		GF83.70-G-4049A