Design of burner housing - GF83.70-P-4000-03A
WARNING: This page does not describe the selected car, but rather 22 other vehicles, including the 2015 Mercedes-Benz G550, 2014 Mercedes-Benz G550, 2013 Mercedes-Benz G550, 2012 Mercedes-Benz G550, and 2011 Mercedes-Benz G550. However, it is still accessible from the selected car via links, so may be relevant.
Model 210 with stationary heater
Model 210 up to 31.08.96 with heater booster
Model 463 as of 01.06.94 with stationary heater
In burner housing,
- burner pipe (2),
- burner with burner insert (1),
- glow pin (A6r2)
and
- flame monitor (A6r3)
are combined as one unit.
Coolant supply (4) and coolant outlet (3) are located on burner housing.
Illustration shows burner housing of stationary heater unit with coolant circulating pump (A6m1) connected. On heater booster heater unit without circulating pump, pump installation opening on burner housing is sealed tight with a sealing plug.
With stationary heater unit, version of burner insert depends on fuel.
Differentiating feature:
- Burner insert for petrol (5) with perforated plate
- Burner insert for diesel (6) with non-woven material
Heater booster heater unit is designed, in principle, for diesel operation.