Headlight switch off delay function - GF82.10-P-2011G

MODEL 463.306 /336 /346 as of model year 2011 /YoM 10 

MODEL 463.202 /222 /236 /237 as of model year 2009 /YoM 08 

MODEL 463.247 /248 /249 /254 up to 31.8.08 as of model year 2007 

MODEL 463.270 /271 /303 /340 /341 as of model year 2007 

General function sequence for headlamp switch-off delay (SWA) 

The headlamp switch-off delay serves to illuminate the area surrounding the vehicle when it is exited or when locating the vehicle.

• Automatic headlamp on
• Locator lighting

  The individual exterior lights are actuated as follows:

  The front signal acquisition and actuation module (SAM) (N10/1) actuates the following components:

• Left standing and parking lights (E1e3) and right standing and parking lights (E2e3)
• Left front fog lamp (E5/1) and right front fog lamp (E5/2)
• Left front side-marker lamp (E6/9) and right front side-marker lamp (E6/10) (only )

  The rear signal acquisition and actuation module (SAM) (N10/2) actuates the following components:

• Left taillight and parking light (E3e2) and right taillight and parking light (E4e2)
• Left license plate lamp (E19/1) and right license plate lamp (E19/2)
• Left rear side-marker lamp (E6/3) and right rear side-marker lamp (E6/4) (only )

In vehicles with code (Q55) Trailer hitch with reinforced low ball head, the standing/parking lights of the trailer are actuated by the trailer recognition control unit (N28/1) via the 13-pin trailer hitch socket (X58).

Automatic headlamp on 

Function requirements 

• Function activated via the instrument cluster (A1)
• Circuit 61 OFF
• Automatic light switch daylight sensor (B32/1) detects "darkness"

Headlamp switch-off delay function sequence 

After switching off the engine, the vehicle ambient illumination is activated for the period set in the instrument cluster.

When a door or the trunk lid is opened, the function sequence starts again.

Security illumination 

Function requirements 

• Function activated via the instrument cluster
• Terminal 15C OFF
• Automatic light switch daylight sensor detects "darkness"

Locator lighting function sequence 

When the vehicle is unlocked using the transmitter key (A8/1) the locator lighting is activated for a period of approx. t = 40 s.

Function abort 

• Circuit 15C ON
• Open the driver/front passenger door

	Light sensor component description	B32/1	GF54.21-P-6001G
	Component description for front SAM control unit with fuse and relay module	N10/1	GF54.21-P-6070G
	Component description for rear SAM control unit with fuse and relay module	N10/2	GF54.21-P-6030G
	Component description for trailer recognition control unit	N28/1 With code (Q55) Trailer hitch with reinforced low ball head	GF31.19-P-4050G
	Electronic ignition/starter switch control unit (EZS), component description	N73	GF80.57-P-6000G