Retrofitting global positioning system (GPS) antenna - AN82.61-P-7474-04V
Model 210.0
- Mask rear area of roof from top over large surface with masking tape or foil.
- Mark antenna hole (21) in center of roof at dimension (h = 182 mm).
-
- Cut antenna hole (21) out to 18 mm dia. (for CTLEL and GPS roof antenna (A2/49)).
- Cut antenna hole (21) out to 15 mm dia. (for GPS antenna (A2/23)).
- Install antenna in roof, align in vehicle longitudinal direction and press lightly onto roof.
The hole pattern for the front locating pin of the antenna (A2/49) will be marked on the gluing surface (dimension x = 30 mm)
- Mark hole for locating pin and drill with 6 mm dia. bit.
- Install antenna for global positioning system (GPS) (A2/23) in roof, align in vehicle longitudinal direction (arrow) and press on lightly.
- Mark hole for locating pin and drill with 3.5 mm dia. bit.
- Pull adhesive foil off of antenna base.
- Install antenna and align.
- Screw on antenna from inside. Route antenna lead to left C-pillar and fasten with felt (arrow).
- Tie back D-net antenna lead below C-pillar (if no longer required).
- Connect antenna extension lead (11) to antenna.
- Fasten connector (12) to left C-pillar with felt strips (arrows).
- Fasten lead (11) with omega clips (27).
For combination antenna (telephone and GPS)
For GPS antenna
For all antennas
When cutting the holes do not damage paint and roof. Do not remove drilling chips with magnet. Coat bare points on body at holes with primer.