LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2002 >> E430 Base >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Backup Assist & Vehicle Log - Retrofitting & Conversion - 210 Chassis >> Retrofitting & Conversion >> Retrofitting parktronic system (PTS) sensors in front bumper - AN54.65-P-0001-01A

Retrofitting parktronic system (PTS) sensors in front bumper - AN54.65-P-0001-01A

  1. Remove impact absorber at front bumper.
  2. Install new impact absorber (10) with mounts for sensors.
  3. Fit ring (12) to parktronic system (PTS) sensors (11).
    Fig 1: Identifying Ring And Parktronic System (PTS) Sensors
    G04633460Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  4. Insert parktronic system (PTS) sensors (11) from the rear into the mounts of the impact absorber (10).
    Fig 2: Identifying Parktronic System (PTS) Sensors
    G04633461Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  5. Run wiring harness of parktronic system (PTS) of front bumper (3) as illustrated inside bumper and plug together connectors (13), beginning on the right.
  6. Insert shock absorber elements (14) into bumper. (The shock absorber elements fix the wiring harness in place.
    Fig 3: Identifying Shock Absorber Elements
    G04633462Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  7. Take cable to left front connector (X26/27) of parktronic system (PTS) (arrow) out of the shock absorber element (14).
    Fig 4: Identifying Front Connector
    G04633463Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals