Installing instrument - AZ54.65-P-0001-05FF
- Mark the hole pattern for display instrument (2) in the right C-pillar trim as shown in the figure and pre-drill to 6 mm dia.
- Cut out rubber sound insulation material in the area of the hole (arrows).
- Rework mounting hole for display instrument (2) to 30 mm dia.
- Clip display instrument (2) into the side trim as shown in the figure.
- Route connecting cable through the rear panel under the rear-window shelf and connect.
When routing the cable, ensure there is sufficient clearance around the area of the airbag and seat belt.
Models 210.0/6 as of 1.7.99 model year 99