LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2002 >> E430 Base >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Backup Assist & Vehicle Log - Retrofitting & Conversion - 210 Chassis >> Retrofitting & Conversion >> Installing instrument - AZ54.65-P-0001-05A

Installing instrument - AZ54.65-P-0001-05A

    Models 210.0/6 without code 290 or 293 up to 30.06.99 

  1. Mark the center point of the mounting hole for the display instrument on the removed right C-pillar trim as per the diagram.

    IMPORTANT The center line of the seat belt slot serves as a reference line for dimensioning.

  2. Make a 30 mm dia mounting hole at the marked drilling point and clip the display instrument (1) into the trim.
  3. Route the display instrument connection cable downwards when attaching the trim.
  4. Route the connection cable backwards from the C-pillar and in the trunk, route to the left to the control module installation point.

    IMPORTANT Tie connection cable to existing cables or wiring looms. Pay attention to chafe-free routing and attach chafe protection if necessary. Tie back cable if overlength.

    a = 35 mm 

    b = 80 mm 

    Fig 1: Drilling Point And Clip Display Instrument Into Trim
    G04633533Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals