Installing control module - AZ54.65-P-0001-04A
The installation described below is not binding and only represents a possible installation example. The choice of installation point depends on the vehicle equipment. If possible the installation point should be selected so that the control module can be installed with the connection point at the bottom.
- Attach the control module (1) with a screw and nut to the free hole in the top area of the side panel brace in the left of the trunk and mark the second control module mounting hole on the front side of the brace.
- Detach the control module again and drill through the marked drilling point to 6.5 mm dia.
- Attach the control module behind the side panel brace and screw on with 2 screws (4), spacer sleeves (3) and nuts (2).