Removing and installing water collector - AR83.25-P-1402K

MODEL 202 as of 1.9.95, 208 

Illustrated on model 202 

Fig 1: Identifying Water Collector Remove/Install Components - Illustrated On Model 202 (1 Of 3)

Illustrated on model 202 

Fig 2: Identifying Water Collector Remove/Install Components - Illustrated On Model 202 (2 Of 3)

Illustrated on model 202 

Fig 3: Identifying Water Collector Remove/Install Components - Illustrated On Model 202 (3 Of 3)

	Removal, installation
1	Remove cover on left and right air intake		AR83.25-P-1400E
2	Remove wiper system		AR82.30-P-6400E
3	Unscrew rubber mounts (5)
4	Unscrew plastic nuts on outside of left and right water collector
5	Unclip clips (7)
6	Unhook wiring duct (10)
7	Loosen fuel lines, remove clamp (12)
8	Remove firewall center section (11), unscrew screws (13), press out clips (14)	When installing the firewall center section ensure that the rubber grommet for the heater feed hose is seated properly.
9	Remove cover on control module box
10	Remove engine control module and ABS control module
11	Loosen control module box (15), for this purpose unscrew screws (16)
12	Remove water collector (4)	When installing water collector (4) ensure that water drain (8 and 9) is seated properly.
13	Reinstall in opposite order