Remove/install power window on rear side window - AR67.39-P-4150KA
MODEL 208.435 /444 /445 /447 /448 /465 /470
| Remove/install | |||
| Risk of injury due to hands being crushed when window glass is not secure | Secure windows against falling down. | AS67.00-Z-0002-01A | |
| 1 | Remove rear passenger compartment side trim panel | AR68.30-P-4780KA | |
| 2 | Remove sealing rails (7) | ||
| 3 | Unscrew nuts (1) from power window on rear shaft strut (2) | ||
| 4 | Unscrew bolts (3) | ||
| Remove rear shaft strut (2) | |||
| 5 | Unscrew nut (4) from adjustment screw (5) | ||
| 6 | Unscrew nuts (6) for adjustment screws from bottom retaining bracket | ||
| 7 | Remove rear power window with rear side window upward | ||
| 8 | Install in the reverse order | *BE60.00-P-1009-01A | |
| Figure |
TEST AND ADJUSTMENT VALUES, GAP DIMENSIONS AT HOODS, DOORS AND COVERS
| Number | Designation | Model 208.4 | |||
|---|---|---|---|---|---|
| BE60.00-P-1009-01A | Gap dimension | Front door window to soft top | Dimension "Z" | mm | 9.0 (± 1.00) |
| Front door window to rear side window | Dimension "N" | mm | 8.0 (± 2.0) | ||
| Fig. see | AR60.00-P-0700-01KA | ||||