LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2002 >> CL600 >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Axle -- Testing & Repair -- 215 & 220 Chassis >> Testing & Repair >> Replace supporting joint - AR33.20-P-0440 >> Replace supporting joint - AR33.20-P-0440IW >> Pressing off and attaching supporting joint at lower wishbone - AR33.20-P-0440-02IW

Pressing off and attaching supporting joint at lower wishbone - AR33.20-P-0440-02IW

TORQUE SPECIFICATION WHEEL LOCATION, HUB

Number Designation Model 220.08/18 Model 211.08/09/28/29
BA33.20-P-1016-01A Self-locking nut, supporting joint to lower transverse control arm 1st stage Nm 70 70
2nd stage ∠° 50 50
Fig 1: Identifying Thrust Piece (140 589 00 63 00)
G04840777
Fig 2: Identifying Puller (124 589 02 33 00)
G04840778

Pushing off 

  1. Unscrew self-locking nut of supporting joint (7) in lower transverse control arm (4).
  2. SPECIAL TOOL Attach thrust piece (07a).
  3. Use SPECIAL TOOL puller (046) to pry off supporting joint (7).

    NOTES Do not damage rubber boot, as otherwise lubricant may leak from supporting joint (7) and this will lead to increased wear.

  4. SPECIAL TOOL Remove puller (046) SPECIAL TOOL and thrust piece (07a).
    Fig 3: Identifying Supporting Joint, Lower Transverse Control Arm, Puller And Thrust Piece
    G04840779

    Installation 

  5. Clean tapered connection.

    IMPORTANT The cone and thread must be free of grease and oil

  6. Replace self-locking nut and screw on TORQUE SPECIFICATION .

    IMPORTANT Counter ball head with an Allen wrench if necessary.

scientia non olet · About LEMON Manuals