Adjusting tilting/sliding roof panel - AR77.20-P-1100M

Fig 1: Adjusting Tilting/Sliding Roof Panel

MODIFICATION NOTES

20.6.01

Sequence of work steps revised

Step 7 added, step 10 supplement

	Removing, installing
1	Push lining to rear
2	Open tilting/sliding roof approx. 10 cm
3	Remove cover (2)	Push cover (2) away on the outside using a plastic wedge (see arrow) before pulling off.
4	Move tilting/sliding roof to tilt position
5	Remove rail (3) from rubber bellows (4) in direction of arrow	Unclip the rail at the front first.
6	Detach rubber bellows (4) from tilting/sliding roof panel (1) to gain access to the torx bolts (5)	Do not damage the rubber bellows.
	Adjusting
7	Close tilting/sliding roof panel from the tilt position
8	Slacken torx bolts (5)	Torx bit set	Figure
9	Insert cardboard strip (6) into seal joint at rear (see arrows)	Cardboard strip (6): 500 mm long and approx. 2 mm thick.
10	Adjust tilting/sliding roof panel (1) in relation to exterior roof surface	Gap dimensions Before adjusting the height, the tilting/sliding roof panel must always be closed from the tilt position.	*BE77.20-P-1001-01A
		Height adjustment	*BE77.20-P-1002-01A
11	Tighten torx bolts (5)	First tighten the rear bolt and then the front bolt on one side only. Repeat this procedure on the opposite side. When tightening the rear bolts, press towards the rear and slightly downwards with the screwdriver (arrows).	*BA77.20-P-1004-01A
12	Check tilting/sliding roof for proper function and fit
13	Install in the reverse order	If there is wind noise ↓
		Adjust seal on tilting/sliding roof panel	AR77.20-P-1360K

TEST AND ADJUSTMENT VALUES FOR TILTING/SLIDING ROOF

Number	Designation			Model 220	Model 215
BE77.20-P-1001-01A	Gap dimensions	Tilting/sliding roof panel, front	mm	0.15	0.15
		Tilting/sliding roof panel, at sides and rear	mm	0.30	0.30
BE77.20-P-1002-01A	Height adjustment	Measurement position "A" (x)	mm	140	140
		Front: lower than outer roof surface	mm	0 - 1	0 - 1
		Rear: higher than outer roof surface	mm	0 - 1	0 - 1

ELECTRIC SLIDING ROOF

Number	Designation		Model 220	Model 215
BA77.20-P-1004-01A	Bolt, tilting/sliding roof panel to tilting bracket mount	Nm	4	4

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)