Removing and installing outside paneling on A-pillar - AR88.80-P-8500K
MODEL 208.3 /4, 215
Illustrated on model 208.3
Fig 1: Identifying Outside Paneling Remove/Install Components On A-Pillar - Illustrated On Model 208.3 (1 Of 2)
Fig 2: Identifying Outside Paneling Remove/Install Components On A-Pillar - Illustrated On Model 208.3 (2 Of 2)
| Removal | |||
| 1 | Fold back wiper arm | ||
| 2 | Lift rubber channel (2) in lower area | ||
| 3 | Unscrew screw (3) | ||
| 4 | Release slide (4) upward (arrows) | ||
| 5 | Pull off paneling (1), lift at bottom and remove from holders (7) at top (arrows) | ||
| 6 | Put down paneling (1) | ||
| Installation | |||
| 7 | Check rubber channel (2), slider (4) and clips (8) on paneling (1) and position slider (4) to removal position | ||
| 8 | Check sheet metal clip nut (5), clips 6) and holder (7) on A-pillar | ||
| 9 | Move paneling (1) into upper holder (7) with mount, then press paneling (1) onto clips (6) and (8) | ||
| 10 | Lift rubber channel (2) in lower area and pull slider (4) down (to lock) | ||
| 11 | screw (3) into sheet metal clip nut (5) | ||
| 12 | Press knob (arrow) on rubber channel (2) into oblong hole in slider (4) (arrow) | ||
| 13 | Align rubber channel (2) |