Remove/install extinguishing agent line below engine - AR86.10-P-0111MB

MODEL 220.1 /8 with CODE (Z04) Light armoring with CODE (Z07) Top protection with fire extinguishing system 

Shown on model 220.178 

Fig 1: Identifying Extinguishing Agent Line Remove/Install Components Below Engine - Shown On Model 220.178

	Remove/Install
1	Ignition Off, detach transmitter key from the electronic ignition switch control unit
2	Remove fuses no. 54 and no. 58 from rear fuse and relay module	The rear fuse and relay module is located below the right rear seat See ↓
		Fuse assignment of rear fuse and relay box	GF54.15-P-1256-01MB
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
3	Raise vehicle.	Do not damage extinguishing agent lines on fire extinguishing system when jacking up vehicle.
4	Disconnect threaded connection (4)	Installation:  Observe tightening instructions. See ↓
		Tightening instructions for fire extinguishing system extinguishing agent lines	AR86.10-P-0114-01A
5.1	Disconnect threaded connection on left engine compartment extinguishing agent line (1) on left extinguishing agent line distributor fitting (2)	When removing left engine compartment extinguishing agent line (1). Installation:  Observe tightening instructions. See ↓
		Tightening instructions for fire extinguishing system extinguishing agent lines	AR86.10-P-0114-01A
6.1	Disconnect threaded connection of left extinguishing agent line end piece (5) on left extinguishing agent line distributor fitting (2)	When removing left extinguishing agent line end piece (5). Installation:  Observe tightening instructions. See ↓
		Tightening instructions for fire extinguishing system extinguishing agent lines	AR86.10-P-0114-01A
7.1	Disconnect threaded connection of right engine compartment extinguishing agent line (3) on right extinguishing agent line distributor fitting (2)	When removing right engine compartment extinguishing agent line (3). Installation:  Observe tightening instructions. See ↓
		Tightening instructions for fire extinguishing system extinguishing agent lines	AR86.10-P-0114-01A
8.1	Disconnect threaded connection of right extinguishing agent line end piece (6) on right extinguishing agent line distributor fitting (2)	When removing right extinguishing agent line end piece (6). Installation:  Observe tightening instructions. See ↓
		Tightening instructions for fire extinguishing system extinguishing agent lines	AR86.10-P-0114-01A
9	Remove pipe clamps (7) from corresponding extinguishing agent line	Mark position of corresponding extinguishing agent line and pipe clamps (7) to be removed Installation:  First position bolts with pipe clamps (7) and then tighten pipe clamps (7) after aligning and screwing corresponding extinguishing agent line
			*BA86.10-P-1001-01B
10	Install in the reverse order
11	Perform self-test for fire extinguishing system		AR86.10-P-0101-01MB

FIRE EXTINGUISHING SYSTEM