Removing and installing instrument panel - AR68.10-P-1000M
MODEL 220
| Remove | |||
| 1 | Remove electronic ignition switch control module | Do not disconnect electrical connectors and shift lock pull cable |
AR80.57-P-1000M |
| Fig 3 | |||
| 2 | Move selector lever to position "D" | ||
| 3 | Disconnect ground cable of battery | AR54.10-P-0003I | |
| 4 | Remove cover (10) below instrument panel on left | AR68.10-P-1500M | |
| 5 | Disconnect electrical connector from data link connector | ||
| 6 | Remove jacket tube module (14) | AR54.25-P-2802I | |
| 7 | Remove cover (12) below jacket tube | AR68.10-P-1060N | |
| 8 | Remove instrument cluster (A1) | AR54.30-P-6015I | |
| 9 | Remove light module (N7-1) | AR54.25-P-3260I | |
| 10 | Remove paneling from left and right A-pillars | AR68.30-P-4050M | |
| 11 | Remove glove compartment (8) | AR68.10-P-1400M | |
| 12 | Remove trim strip (19) | AR68.10-P-1180M | |
| 13 | Remove left (17) and right (18) side air nozzles | AR68.10-P-1100M | |
| 14 | Unclip right (15) and left (16) front door air nozzles from instrument panel (7) | ||
| 15 | Remove cover (11) below instrument panel on right | AR68.10-P-1520M | |
| 16 | Remove cover (9) from center console | AR68.20-P-2350M | |
| 17 | Remove center air nozzle (24) | AR68.10-P-1150M | |
| 18 | Unclip right (22) and left (23) covers from instrument panel | ||
| 19.1 | Remove Parktronic displays | AR54.65-P-0003B | |
| 20 | Unscrew screws (1-6) from instrument panel | ||
| 21 | Lift instrument panel (7) | ||
| 22 | Unclip loudspeaker from center of instrument panel (7) | AR82.62-P-7833I | |
| 23 | Lift instrument panel (7) out through open passenger door | ||
| 24 | Lay instrument panel (7) down on suitable base | ||
| Install | |||
| 25 | Insert sheet metal clip nuts (6 each) in cross member (25) for mounting instrument panel (7) | ||
| 26 | Position instrument panel (7) in passenger compartment through open passenger door and install on cross member (25) | ||
| 27 | Clip loudspeaker into center of instrument panel (7) | AR82.62-P-7833I | |
| 28 | Screw in screws (1-6) | ||
| 29 | Screw jacket tube cover (12) to instrument panel (7) | ||
| 30 | Clip right (22) and left (23) covers into instrument panel | ||
| 31 | Install Parktronic displays | AR54.65-P-0003B | |
| 32 | Install electronic ignition/starter switch control module | Fig 3 | |
| AR80.57-P-1000M | |||
| 33 | Clip right (15) and left (16) front door air nozzles into instrument panel (7) | ||
| 34 | Install left (17) and right (18) side air nozzles | AR68.10-P-1100M | |
| 35 | Install center air nozzle (24) | AR68.10-P-1150M | |
| 36 | Install cover (9) on center console | AR68.20-P-2350M | |
| 37 | Install glove compartment (8) | AR68.10-P-1400M | |
| 38 | Install cover (11) below instrument panel on right | AR68.10-P-1520M | |
| 39 | Connect electrical connector for data link connector | ||
| 40 | Install light module (N7-1) | AR54.25-P-3260I | |
| 41 | Install jacket tube module (18) | AR54.25-P-2802I | |
| 42 | Install instrument cluster (A1) | AR54.30-P-6015I | |
| 43 | Install trim strip (19) | AR68.10-P-1180M | |
| 44 | Install cover (10) below instrument panel on left | AR68.10-P-1500M | |
| 45 | Install paneling on left and right A-pillars | AR68.30-P-4050M | |
| 46 | Reconnect ground lead to battery | AR54.10-P-0003I | |
| 47 | Carry out operational check | ||
| 48 | Read out fault memory |