Retrofitting sun blind for rear side window - AN68.50-P-0002M: Notes

MODEL 220.026 /028 /063 /065 /070 /075 /128 /165 /170 /175 /178 except CODE (979) Special protection version 

Fig 1: Identifying Retrofitting Sun Blind For Rear Side Window - Model 220.026

Fig 2: Identifying Protective Rubber And Clip

Fig 3: Identifying Guide Rail And Centering Holes

Fig 4: Locating Protective Cap And Screw

	Removing
1	Remove door lining (1) from rear door	The door lining is no longer required.
			AR72.12-P-1010M
2	Remove inside door frame trim (2)
3	Loosen protective rubber (3) and remove rear clips (4)	The clips are no longer required.
	Installing
4	Press in clip (5) and push on protective rubber (3)	The clip (5) is a new part.
5	Make cutouts for bracket (7) and guide rail (8) in door frame trim (2)
5.1		Drilling template for side window sun blind for vehicles with standard wheelbase.	AN68.50-P-0002-01MA
5.2		Drilling template for side window sun blind for vehicles with long wheelbase.	AN68.50-P-0002-01MB
6	Install inside door frame trim (2)
7	Fit bracket (7) and mark holes for screws (6)	Only if holes are not already present. If hole is present, insert retainer (dowel).
8	Fit guide rail (8) and mark hole for screw (10)	Only if hole is not already present. If hole is present, insert retainer (dowel).
9	Detach inside door frame trim (2)
10	Drill marked holes (2 mm)	Mask off area where drill swarf falls. Finish drilled holes and prime and paint with approved painting products.
11	Install inside door frame trim (2)
12	Install door lining with window blind (1) on rear door	The door lining is a new part.
			AR72.12-P-1010M
13	Screw on bracket (7) with screws (6)
14	Insert guide rail (8) into centering holes (9) provided, extend rail and tighten screw (10)	Aligned parallel to window separator bar.
15	Tighten screw (11) and press on protective cap (12)
16	Carry out function check