Retrofitting CD changer - AN82.64-P-0001NA: Notes

MODEL 215.375 /376 /378 1# as of 1.9.02 with CODE (803) Model year 2003 except CODE (810) Sound system except CODE (813) Voice control system (VCS) except CODE (852) CTEL preinstallation assembly at dome except CODE (853) MB standard cellular telephone except CODE (854) MB portable cellular telephone except CODE (855) TELE AID 

Fig 1: Identifying CD Player With Changer, COMAND Operating, Display And Control Module

Fig 2: Identifying CD Changer Remove/Install Components

	Notes on fiber optic cable	Model 215 with code (819) 6-disk CD changer.	AH82.70-P-0001-02A
	Notes on D2B ring		AH82.70-P-0001-03MN
	Remove
1	Remove front seats	To prevent the airbag system from being damaged  in the seat, and because the center console has to be removed, the gear lever has to be in position N,  the ignition key in position 0,  and then the ground wire at the battery has to be disconnected  before the electrical connector is disconnected at the seat. ↓
			AR91.10-P-1000N
		Disconnect ground cable of battery	AR54.10-P-0003I
2	Remove cover on center console
			AR68.20-P-2350N
3	Remove center console
			AR68.20-P-2000N
4	Remove rear seat cushion
			AR91.12-P-1020N
5	Remove rear backrest
6	Remove side wall paneling	Only on left side.
			AR68.30-P-1450N
7	Remove floor covering in rear	Remove only until the floor covering on the driver's side can be lifted and the cable ducts on the left are accessible.
			AR68.20-P-4800N
8	Unscrew screws (41) from left and right reinforcement struts (42) and remove reinforcement strut (42)
9	Pull out center rear ventilation duct (43) towards the back from the center front ventilation ducts (46)
10	Pull out center front ventilation ducts (46) towards the back from the blower box
11	Pull out left rear ventilation duct (44) towards the back from the left front ventilation duct
12	Open center left cable duct (45) and left rear cable duct (49)
13	Unclip Bowden cable of park pawl (47) from center front cable duct cover (48)	Do not adjust or damage Bowden cable of park pawl (47).
14	Unclip center front cable duct cover (48) and remove
15	Remove coverings in trunk	Left side paneling and on rear wall If a side lining is installed without access door for the CD changer, then it has to be replaced with one that has an access door.
			AR68.30-P-4600M
	Install
16	Retrofit fiber optic wiring harness		AN82.70-P-0002-01NA
	Cover fiber optic cable	Do not kink or stretch D2B fiber optic cable.  Install cover caps on optical waveguide connector and equipment connection.	AR82.95-P-0005-01A
17	Retrofit CD changer in trunk		AN82.64-P-0001-04NA
18	Fit remaining parts to vehicle	Steps 15 to 1
19	Conduct startup with STAR DIAGNOSIS
20	Check for proper function	See owner's manual.
21	Add special equipment entry to the vehicle data card and to online vehicle data card	6-disk CD changer (code 819).