LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2002 >> C32 >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Axle -- Testing & Repair -- 203 Chassis - 1 Of 2 >> Testing & Repair >> Remove/install supporting joint on wheel carrier - AR35.20-P-0116-01B

Remove/install supporting joint on wheel carrier - AR35.20-P-0116-01B

Fig 1: Identifying Extractor And Insertion Tool (202 589 00 43 00)
G04636270

    Remove 

  1. Pull supporting joint (7a) out of wheel carrier (7)using removal and installation tool SPECIAL TOOL (06c, 06h, 7i) and remove.

    IMPORTANT The recess in the counter sleeve SPECIAL TOOL (06i) must face outwards to the wheel carrier.

    Fig 2: Identifying Clamping Bolt, Thrust Piece, Wheel Carrier And Support Joint
    G04636271

    2. Install 

  2. Attach removal and installation tool SPECIAL TOOL (06c, 06h, 06i) with supporting joint to wheel carrier (7).
  3. Pull supporting joint (7a) into wheel carrier from behind using removal and installation tool SPECIAL TOOL .
    Fig 3: Identifying Supporting Joint And Wheel Carrier
    G04636272

Wheel carrier with surfaces machined on both sides

IMPORTANT The supporting joint must protrude the same distance on both sides (centrally from boss).

Wheel carrier with chamfer

IMPORTANT The supporting joint outer sleeve must fit flush with the chamfer of the small dia. on the wheel carrier (arrows).

Fig 4: Locating Wheel Carrier
G04636273
scientia non olet · About LEMON Manuals