Radial sealing ring and joint flange on drive pinion modified - BT35.31-P-0012-01C

As of 15.01.02 

Rear axle center assembly dia. 198 in MODEL 129.058 as of 1.6.94, 129.059, 129.063 as of 1.6.94, 129.064, 140.02 /03 as of 1.6.94, 170.465 /466, 202.033 /093 /133 /193, 203.006 /064 /206 /264 /706, 208.365 /370 /465 /470, 210.006 /015 /017 /025 /045 /053 /055 /063 /065 /08 /206 /215 /217 /225 /245 /263 /265 /28 /606 /663, 220.063 /065 /165 

Rear axle center assembly dia. 198 in MODEL 202.085 with TRANSMISSION 717 

Rear axle center assembly dia. 198 in MODEL 202.134 /194, 203.004 /204, 210.007 with CODE (450) Taxi version 

Rear axle center assembly dia. 210 in MODEL 129.068, 129.076 as of 1.2.98, 208.374, 210.016 /026, 210.070 /074 as of 1.2.98, 210.216 /226, 210.270 /274 as of 1.2.98, 210.616, 215.375 /378, 220.026 /070 /075 /170 /175 /178, 230.475 HA- 210E 

A new radial sealing ring and a new joint flange with protection ring were phased in as of 15.01.02.

This improves the sealing at the drive pinion against dirt from outside.

Version as of 01.04.98 up to 14.01.02 

If repair work means that one of the two components (new joint flange or new radial sealing ring) is replaced for the first time, then both must be replaced together.

Only then is correct sealing guaranteed.

Shown on rear axle center assembly dia. 185 mm 

Version as of 15.01.02 with double labyrinth seal