Removal & Installation (With Code 287a)

Pull locking plate (6) and fold rear seat cushions (l and 2) forwards. See Fig 1.
Unscrew nuts of support belt on rear seat cushion (5) on vehicle floor. When installing tighten nuts to torque specifications. See TORQUE SPECIFICATIONS .
Fold down 2/3 rear seat cushion (1), 1/3 rear seat cushion (2).
Unclip protective caps.
Unscrew hinge nuts of rear seat cushion (3) on vehicle floor. On installation align supporting plate (4), and tighten nuts to torque specifications. See TORQUE SPECIFICATIONS .
Install disassembled components in reverse order.

Fig 1: Removing & Installing Rear Seat Cushion (With CODE 287a)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.