Electronic ignition/starter switch (EZS) removal and installation - AR46.10-P-0810P

MODEL 203, 209 

Fig 1: Identifying Electronic ignition/starter switch Bolts

Fig 2: Identifying Claw-Type Wrench And Rosette

Fig 3: Locating Ignition Switch Cable And EIS [EZS] Control Unit

MODIFICATION NOTES

16.5.06

"Disconnect/connect ground line on battery" removed

	Remove/install
1	Completely move steering column downward or press completely downward
2	Remove cover below instrument panel		AR68.10-P-1500P
3	Remove rosette (36a) from lower section of instrument panel using claw-type wrench (020)	Claw-type wrench for rosette on ignition/ start switch.	Fig 4
4	Remove bolt (1)	Carefully pull panel downwards so that the EIS [EZS] control unit (N73) can be removed more easily.
5	Remove EIS [EZS] control unit (N73)
6	Remove ignition switch cable (36h)	Vehicles with automatic transmission. Press together retaining clips (arrows) and pull the ignition switch cable (36h) forward out of the retaining lugs.
7	Disconnect electrical connectors	Four connectors.
8	Install in the reverse order

Fig 4: Identifying Claw-Type Wrench For Rosette On Ignition Switch (210 589 00 07 00)