Removing and installing rear side window molding - AR67.30-P-4010PA

MODEL 203.2 

Fig 1: Identifying Rear Side Window Molding Remove/Install Components - Model 203.2

	Removing
1	Open rear door
2	Remove cover (1)
3	Unclip bottom molding (2)	Assembly wedge	Figure
4	Remove bottom molding (2)
5	Unclip top molding (3)	Assembly wedge Start at front at the first three mounting clips (5)	Figure
6	Move top molding (3) toward front	This loosens the top molding (3) from the last mounting clip.
7	Remove top molding (3)
	Installing
8	Check mounting clips (4) and (5)	Replace damaged mounting clips (4) and (5).
9	Align top molding (3) at mounting clips (5) and press on	Use lubricant	*BR00.45-Z-1010-06A
10	Align bottom molding (2) at mounting clips (4) and press on
11	Check molding (3) and (4) position, correct if necessary.
12	Install cover (1)
13	Close rear door

Fig 2: Identifying Assembly Wedge (110 589 03 59 00)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1010-06A	Antifriction agent	A 000 989 03 67