Aligning windshield in body opening - AR67.10-P-1000-04PB
MODIFICATION NOTES
| 18.1.01 | Value changed from 2.5 (± 0.5) mm to 2 (± 1) mm Value changed from 2 (+0.5) mm to 2 (± 1) mm Value changed from 9,5 (± 0.5) mm to 9 (± 1) mm Value changed from 7.5 (± 0.5) mm to 7 (± 1) mm |
Value in BE77.20-P-1007-01A changed on model 203.7 | *BE77.20-P-1007-01A |
TEST AND ADJUSTMENT VALUES FOR SLIDING/POP-UP ROOF
| Number | Designation | Model 203.7 | ||
|---|---|---|---|---|
| BE77.20-P-1007-01A | Gap dimensions | Wind deflector to sliding/pop-up roof | mm | 2 (±1) |
| Sliding/pop-up roof to glass roof, rear | mm | 2 (±1) | ||
| Glass roof, rear, to rear window | mm | 9 (±1) | ||
| Windshield to outer mounting clamp of trim strip | mm | 7 (±1) | ||
- Before applying glue position windshield on window rubber spacers, adjust distance of windshield to outer mounting clips of trim strip and align at side.
- Glue on adhesive strips, cut at window top edge and remove windshield