Removing and installing rear spoiler - AR72.20-P-4000PA

MODEL 203.2 

Fig 1: Identifying Rear Spoiler Removing And Installing Components

	Removing
1	Remove liner on tailgate		AR68.30-P-1050PA
2	Disconnect center high-mounted stop lamp connector (X20/1)
3	Unscrew nuts (1)
4	Unclip rear spoiler (2)	when tailgate is closed to prevent paint damage.
			Figure
5	Remove rear spoiler (2)
6	Unscrew clips (3) from rear spoiler (2).	For this purpose turn stud bolt (4) with 3 mm Allen wrench.
	Inspecting
7	Check rear spoiler seal (2)	Replace if damaged.
	Installing
8	Press clips (3) into tailgate	Observe tight seat. Use new clips (3).
9	Position rear spoiler (2) and press on.
10	Tighten stud bolt (4).	Tighten hand-tight with 3 mm Allen wrench. Start at center of tailgate to prevent rear spoiler (2) from tensioning and to avoid leakage.
11	Tighten nuts (1).
12	Disconnect center high-mounted stop lamp connector (X20/1)
13	Install door liner on rear door		AR68.30-P-1050PA
14	Perform function check

Fig 2: Identifying Assembly Wedge (110 589 03 59 00)