Removing and installing rear door lock - AR72.12-P-2510P

MODELS 203.0 /2 

Illustrated on Model 203.0 

Fig 1: Identifying Rear Door Lock Remove/Install Components (1 Of 2)

Fig 2: Identifying Rear Door Lock Remove/Install Components (2 Of 2)

Illustrated on model 203.0 

	Removing, installing
1	Remove door liner from rear door		AR72.12-P-1010P
2	Remove side airbag in rear door	With code (293) side airbag in left and right rear	AR91.60-P-0692P
3	Pull foil off of inner door panel
4	Remove Styrofoam insert (14)	Installed as two-piece element
5	Remove outer door handle on rear door		AR72.12-P-2410P
6	Detach couplings of cable (1) at door control module	At rear left door control module (N69/3), right rear door control module (N69/4)
7	Expose cable (1) up to door lock (3)
8	Unscrew screws (2)	Screws on door lock	*BA72.12-P-1005-01A
		Torx bit set	Figure
9	Take out door lock (3) through assembly opening
10	Install in the reverse order
11	Carry out operational check

REAR DOOR

Fig 3: Identifying Torx Bit Set (000 589 01 10 00)