Prepare roofliner for installation of interior motion sensor transmitter and receiver unit - AN80.50-P-0100-03P

Model 203 with Code 551a (anti-theft-alarm system) 

1. Place reinforcing frame (1) of interior motion sensor transmitter/receiver (A26/14) on the insider of the roofliner as shown in figure and center.

   Place inner edge of reinforcing frame (1) at distance a, with the wider cutout of the reinforcing frame (1) facing in the direction of motion.

2. Draw inside contour of reinforcing frame (1) on the roofliner.
3. Cut out roofliner according to contour drawn.
   Fig 1: Identifying Reinforcing Frame & Roofliner Dimensions

   
4. Enlarge corners of cutout contour as shown in figure.

   The corners are enlarged to ensure stress-free seating of the interior motion sensor transmitter/receiver (A26/14).

5. Cut out marked area from roofliner.
   Fig 2: Identifying Corners Of Cutout Contour Dimensions

   
6. Insert reinforcing frame (1) from the rear of the roofliner into the installation opening.
7. Bend retainer tabs (arrows) from the front of the roofliner.
   Fig 3: Locating Retainer Tabs On Reinforcing Frame