Connect/route interior motion sensor's wiring harness - AN80.50-P-0100-02P

Model 203 with Code 551a (anti-theft-alarm system) 

1. Route wiring harness on roofliner along existing wiring harnesses (arrows) and secure with strips of adhesive tape.
   Fig 1: Locating Wiring Harness On Roofliner Along Existing Wiring Harnesses

   
2. Contact coupling (1) to overhead control panel control module (N70).
   Fig 2: Identifying Coupling To Overhead Control Panel Control Module

   
3. Contact ATA-IMS connector (X42/28) to interior motion sensor transmitter/receiver (A26/14).
   Fig 3: Identifying ATA-IMS Connector To Interior Motion Sensor Transmitter/Receiver