Remove/install operating, display and control unit - AR82.85-P-7472P

MODEL 203 up to 23.4.04 with CODE (352) COMAND operating and display system 

Fig 1: Identifying COMAND Operating Display And Controller Unit - Model 203 Up To 23.4.04 With Code (352)

Fig 2: Identifying Operating Display And Control Unit Connectors - Model 203 Up To 23.4.04 With Code (352)

	Remove/install
1.1	Transfer basic data from the COMAND operating, display and controller unit (A40/3) to STAR DIAGNOSIS	When replacing the COMAND operating, display and controller unit (A40/3). Installation:  Transfer temporarily stored basic data to the new COMAND operating, display and controller unit (A40/3).
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
		STAR DIAGNOSIS diagnosis system	*WH58.30-Z-1048-13A
2	Remove cover on center console		AR68.20-P-2350P
3	Remove bolts (3)
4	Remove COMAND operating, display and controller unit (A40/3)
5	Disconnect RGB signal connector from TV tuner (1), CAN connector to instrument cluster (2) and power supply connector (A)
6	Disconnect speaker connector (B) and FM/AM antenna signal input connector (D)
7	Disconnect GPS antenna signal input connector (E) and IF signal output connector (F)
8	Disconnect digital data bus connector (D2B)	To avoid damage, do not kink or stretch digital data bus connector (D2B).
		Fit digital data bus connector (D2B) and equipment connector with caps and cover.	AR82.95-P-0005-01A
	Notes on fiber optic cable	Model 129, 168, 170, 202, 203, 208, 210, 215, 220, 463	AH82.70-P-0001-02A
9	Install in the reverse order