Remove/install lamp unit holder - AR82.10-P-4740P
MODEL 203, 209
Shown on model 203.0
MODIFICATION NOTES
| 24.5.06 | "Disconnect/connect ground line on battery" removed |
| Removing | |||
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| 1 | Remove lamp unit | Model 203 | AR82.10-P-4730PA |
| Model 209 | AR82.10-P-4730QA | ||
| 2 | Cut off outer bracket (1), middle bracket (2) and inner bracket (3) | ||
| Body saw (electric/pneumatic) | *WE58.40-Z-1004-03A | ||
| 3 | Clean and deburr separation points on lamp unit | ||
| Install | |||
| 4 | Remove adjusting bushes (4) | ||
| 5 | Screw new holders to lamp unit | ||
| 6 | Install lamp unit | ||
| Model 203 | AR82.10-P-4730PA | ||
| Model 209 | AR82.10-P-4730QA | ||
| 7.1 | Set electrical zero position of headlamp range adjustment | On vehicles with code (612b) Xenon headlamp unit | |
| 8 | Check headlamp adjustment | ||
| Check and correct headlamp adjustment | AP82.10-P-8260P |
WORKSHOP EQUIPMENT
| WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |