Adjusting wiper system - AR82.30-P-6400-01P

Model 203, 209

WIPER ARM TEST AND ADJUSTMENT VALUES

Number	Designation		Model 203	Model 209
BE82.30-P-1003-01E	Angle of incidence of wiper arm on driver-side in parked position	∠ °	1.5...5.5	1.5...5.5

WINDSHIELD WIPER

Number	Designation		Model 203	Model 209
BA82.30-P-1007-01A	Nut/screw, wiper system to partition wall	Nm	8	8

Fig 1: Identifying Pulling Hook (140 589 02 33 00)

Fig 2: Identifying Adjustment Tool Set (211 589 02 21 00)

The wiper system may only be adjusted if the test values of wiper arms deviate from the tolerance range in parked position.

The specified adjustment values are only valid for left-hand drive vehicles. For right-hand drive vehicles, the corresponding sign has to be changed.

Fig 3: Adjusting Wiper System - Shown On Model 209

Shown on model 209

Install choke angle gauge (A) to driver-side wiper arm (1).
Open hood.
See Operating Instructions
Loosen bolt (2) and attach pulling hook (3) to the wiper system.
Move wiper system with pulling hook (3) horizontally until the correct adjustment value is shown on the dial of the choke angle gauge (A).
Tighten bolt (2) and remove pulling hook (3).
Close hood and remove choke angle gauge (A) from driver- side wiper arm (1).