Retrofit portable CTEL holder of hands-free system - AZ82.70-P-0005-01P

When installed on side of telephone 

1. Align base holder (2) on side of telephone (7), mark holes and drill with 3mm dia. bit.
2. Screw base holder (2) onto side of telephone with the 3 sheet metal screws (3) included.
   Fig 1: Identifying Base Holder, Screws And Telephone

   
3. Insert portable cellular telephone holder (1) into base holder (2).
4. Hook connection lead below side of telephone (7) with coil of spiral lead as shown in figure (arrow) and arrest from inside with adhesive felt.
   Fig 2: Identifying Portable Cellular Telephone Holder And Base Holder

   
5. Route connector (8) into radio shaft.
   Fig 3: Identifying Connector Routed Into Radio Shaft