Telephone switch-on/off characteristics (D-network), function - GF82.70-P-2005B
MODELS 129, 163, 203, 208, 209.3 /4, 210, 215, 220 with CODE (853) MB standard cellular telephone with CODE (854) MB portable cellular telephone
General
The status of the telephone in the D2B ring depends exclusively on the status of circuit 15 (ignition ON/OFF). Information on the state of "circuit 15" is sent over the D2B ring to the telephone transmitter/ receiver, D2B (A35/13), the telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) from the radio (A2) or the COMAND operating, display and control unit (A40/3) (except model 129). The telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) do not have any electrical connection to "circuit 15" and they are switched on or off by a Head Unit command, via the D2B ring or an external wake-up line.
For "circuit 15 OFF" the telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) and thus the telephone or the telephone interface (A34/4) is switched on with the portable CTEL for a run-on time of t = 10min. to t = 60 min. (run-on time is parameterizable) and it is then switched off again.
System characteristics
The telephone control unit for the telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) have 3 operating conditions.
- Powerdown mode
The telephone control unit is switched off with the exception of the external wake-up line.
- Idle mode or run-on time mode
The remaining components of the D2B ring are switched off; only the telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) is active during the run-on time, after the D2B ring "circuit 15 OFF" has been switched off. During the run-on time the telephone can be used without any PIN inquiry.
- Active mode
The telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4), and the remaining components in the D2B ring are active and available to the user.
Switch-on process
1st state: "Circuit 15 ON", telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) is in inactive state (Powerdown mode), the telephone system is not operational.
The telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) is activated (Active mode) when:
- the portable CTEL (A34/6) or the telephone handset (A34) is switched on.
- a call is made or received with the telephone switched on.
- a wake-up signal from another D2B ring subscriber is recognized via the external wake-up line.
2nd state: "circuit 15 OFF", telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) are in the run-on phase (Idle mode).
The telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) is activated (Active mode) when:
- a call is made or received with the telephone switched on.
- a wake-up signal from another D2B ring subscriber is recognized via the external wake-up line.
Switch-off procedure
The telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) is in the run-on phase (Idle mode) and the D2B ring is switched off.
The following cases are possible:
- For "circuit 15 ON" and expiry of the run-on time of t = 10 min. to t = 60 min. (run-on time is parameterizable) and no further presses of a button on the telephone during the run-on time the telephone transmitter/receiver D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) is switched off (Powerdown mode). In doing so the state of the telephone is not altered, in other words, an active telephone remains switched on and is not switched off by the telephone transmitter/receiver, D2B (A35/13), or telephone transmitter / receiver (A35) (for model 163).
- For "circuit 15 OFF" and expiry of the run-on time and no further presses of a button on the telephone during the run-on time the telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) or the telephone interface (A34/4) is switched off (Powerdown mode). In this case, the status of the telephone changes, meaning, a switched on telephone is switched off.
When the D2B ring is deactivated, the telephone transmitter/receiver, D2B (A35/13), telephone transmitter / receiver (A35) (for model 163) is switched off, if neither the telephone is switched on nor the receiver is on the cradle.
| CTEL antenna, location / task | Model 163 Models 208.3, 215 with code (855) TELE AID Models 203, 210 and 220 with code (855) TELE AID and code (930) taxi emergency call |
GF82.62-P-4105P | |
| Models 203, 209.3 | GF82.62-P-4105PP | ||
| Model 209.4 | GF82.62-P-4105Q | ||
| Compensator, location/task | Models 209.3/4 | GF82.70-P-3109Q | |
| Hands-free system microphone, location/task | Models 203, 208.3, 210, 215, 220 with code (855) TELE AID Models 203, 210, 220 with code (930) taxi emergency call Model 210 with code (348) TELE AID emergency call system Models 129, 208.3, 210, 215, 220 with code (347) TELE AID emergency call system (D2B) |
GF82.70-P-4102A | |
| Models 209.3/4 | GF82.70-P-4102Q | ||
| Hands-free system speaker, location/task | Models 163, 203 Models 129, 210 with code (274) MB D-net telephone, code (312) D-net portable CTEL, code (313) D-net "portable CTEL", code (314a) D-net "Standard" telephone, code (316) MB D-net telephone (D2B), code (317) D-net portable CTEL (D2B) Models 215, 220 with code (316) MB D-net telephone (D2B), code (317) D-net portable CTEL (D2B) Model 208 with code (274) MB D-net telephone, code (316) MB D-net telephone (D2B), code (317) D-net portable CTEL (D2B) |
GF82.70-P-4103B | |
| Model 209.3 with code (852) portable CTEL preinstallation assembly on dome, code (855) TELE AID | GF82.70-P-4103Q | ||
| Model 209.4 with code (852) portable CTEL preinstallation assembly on dome, code (855) TELE AID | GF82.70-P-4103QA | ||
| Telephone transmitter/receiver (D-network), location/task | Models 209.3/4 with CODE (853) MB Standard telephone | GF82.70-P-4107Q | |
| Telephone interface, location/task/design/function | GF82.70-P-3107Q | ||
| Telephone handset (D-network), location/task | Models 209.3/4 with CODE (853) MB Standard telephone | GF82.70-P-4106Q | |
| Models 163, 203 Models 129, 210 with code (274) MB D-net telephone, code (314a) D-net "Standard" telephone, code (316) MB D-net telephone (D2B) Model 208 with code (274) MB D-net telephone, code (316) MB D-net telephone (D2B) Model 215, 220 with code (316) MB D-network telephone (D2B) |
GF82.70-P-4106C | ||
| Portable cellular telephone (D-network), location/task | Models 209.3/4 with CODE (854) MB portable CTEL | GF82.70-P-4110Q |