Active service system (ASSYST), Mercedes-Benz driver information service - GF00.20-P-0003-02F
Remaining time (The example shows the representation for Service A)
Shown on model 203 up to 23.4.04
Conditions:
- Remaining time (in days) x 40 < remaining distance (in km)
- Remaining time (in days) x 20 < remaining distance (in miles)
The remaining time is displayed:
- Automatically after the warning threshold has been reached; 5 s after the ignition key (models 208, 210) or the transmitter key (A8/1) (model 203) was turned into position "circuit 15 ON" or the engine was started.
The service symbol and "Service A/B in xxxx days" appear for 30 s.
- Automatically once the remaining time has expired; 5 s after the ignition key (models 208, 210) or transmitter key (A8/1) (model 203) was set to position "circuit 15 ON" or the engine was started. The service symbol and "Perform Service A/B" appear for 30 s.
- Automatically after the remaining time has expired; 5 s after the ignition key (models 208, 210) or the transmitter key (A8/1) (model 203) was turned to position "circuit 15 ON" or the engine was started. The service symbol and "Service A/B exceeded by xxxx days" appear for 30 s. Additionally, a brief warning chime is sounded
- Upon driver request, the service symbol and "Service A/B IN xxxx days" appear for 30 s.
The display is carried out with a resolution of one day.
It can be suppressed by actuating the reset button on the instrument cluster (A1).
If the Active Service System (ASSYST) is lacking measured values due to sensor failure, for example, it switches to stored substitute values. A corresponding entry is made in the diagnostic trouble code memory of the relevant control unit. If the operating voltage fails, the data are retained. The times without operating voltage (empty or disconnected batteries) are not recorded, but may be subsequently taken into consideration via STAR DIAGNOSIS.