Determining fused components with excessive quiescent current consumption - AR54.10-P-1030-05P

Fig 1: Identifying Electrical Connection Set (201 589 00 99 00)

Fig 2: Identifying Quiescent-Current Test Adapter 1 (140 589 12 21 00)

Fig 3: Identifying Quiescent Current Test Adapter 2 (140 589 13 21 00)

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1001-09A	Multimeter

Ascertain potential quiescent current consumer on the relevant fuse. See assignment and cable connections of fuse blocks, insert sheet or "Wiring Diagrams" for models 203, 209, 463.
For location of components refer to "Wiring Diagrams" for models 203, 209, 463.
Disconnect connector on potential quiescent current consumer.
The second multimeter is connected to the electrical connection set via the quiescent current test adapter instead of the corresponding fuse.

If any connectors were disconnected from control modules, the current consumption may increase for up to four minutes (or up to 30 minutes in the case of the overhead control panel control module (N70)).
Read off quiescent current on second multimeter:
- Quiescent current ≤ 20 mA:
  Quiescent current error is rectified after disconnecting the connector of the relevant component. The component is probably defective. To check, re-test the total quiescent current again.
- Quiescent current > 20 mA:
  Quiescent current error remains after disconnecting the connector. The component is OK. Reconnect the connector to the tested component.
Perform test with all components at the appropriate fuses as described above.