Remove and install rear seat backrest cover - AR91.18-P-1870P
MODELS 203.0, 209.3
Illustrated for code (287a) Through-loading feature
Fig 1: Identifying Rear Seat Backrest Cover Remove/Install Components - Illustrated For Code (287A) Through-Loading Feature
Illustrated with code (287a) through-loading feature
| Remove/install | |||
|---|---|---|---|
| 1 | Remove rear headrests | AR91.16-P-1770P | |
| 2 | Remove rear seat backrest (12) | With model 203 | AR91.12-P-1720P |
| on model 209 | AR91.12-P-1720Q | ||
| 3 | Set rear seat backrest (12) down on a suitable surface | ||
| 4.1 | Remove the ski bag (6) | Cf. Code (282) ski bag | |
| 4.2 | Undo screws (3), remove through-loading covering in rear wall (4) and through-loading paneling in rear wall (5) | With code (287a) through-loading feature | |
| 5 | Remove rear wall cover (1) | ||
| 6 | Dislodge the seat cover material (9) from the attachment groove running around the rear backrest frame | ||
| 7 | Turn the screw out of the vehicle center bracket (2) | ||
| 8.1 | Remove the interior side trim frame (14) | With code (287a) through-loading feature | |
| 9 | Undo screws on rear armrest (13). | ||
| 10 | Remove rear armrest (13) | ||
| 11 | Dislodge seat cover material (9) from the attachment groove running around the rear backrest opening for the armrest (13) | ||
| 12.1 | Undo cover (10) for seat belt | Model 203.0 | |
| 13 | Take off cover (7) | ||
| 14 | Remove headrest guides (11) | ||
| 15 | Unhook staple wire on rear seat backrest frame | ||
| 16.1 | Carefully pull out the safety belt | Model 203.0 | |
| 17 | Take off the seat cover (9) along with the foam padding (24) | ||
| 18 | Pull the seat cover (9) over the foam padding (24) | ||
| 19 | Undo clips (22) for longitudinal stapling and cross stapling | ||
| 20 | Pull the stitching wires (23) out of the fabric sleeves | ||
| 21 | Install in the reverse order |