Remove/install front bumper - AR88.20-P-2000P

MODEL 203 (except 203.076 /276) 

Fig 1: Identifying Front Bumper Remove/Install Components - Model 203 (Except 203.076 /276)

Fig 2: Identifying Front Bumper Gap Dimension - Model 203 (Except 203.076 /276)

	Remove/Install
1	Remove fender liner in front fender	Remove front fender liner and detach center fender liner	AR88.10-P-1300P
2	Unscrew bracket bolt (4)	Bolt, front bumper to side inner fender	*BA88.20-P-1004-01A
3	Pivot bracket (3) to middle of vehicle, pull toward rear and remove
4	Remove outside temperature indicator temperature sensor		AR54.30-P-6341P
5	Disconnect connectors from left fog lamp (E5/1) and right fog lamp (E5/2)
6	Unscrew bolts from bumper (2)	Bolts, front bumper to crossmember	*BA88.20-P-1006-01A
7	Remove bumper (1) toward front	Installation:  Checks gaps for bumper (1), correct adjustment screw (5) if required	*BE88.20-P-1001-01A
		Feeler gage	Fig 3
8	Modify AMG-bumper	See installation instructions for accessories: ↓
		Retrofit AMG trims	AZ88.00-P-0001L
9	Install in the reverse order
10	Check and correct headlamp adjustment
		Model 203	AP82.10-P-8260P

BUMPER GAP DIMENSIONS

Number	Designation			Model 203
BE88.20-P-1001-01A	Dim.	Front bumper, gap dimension "A"	mm	5
		Fig., see		AR88.20-P-2000P

BUMPER

Number	Designation		Model 203
BA88.20-P-1004-01A	Bolt, front bumper to side inner fender	Nm	4
BA88.20-P-1006-01A	Bolt, front bumper to crossmember	Nm	4

Fig 3: Identifying Feeler Gage (129 589 03 21 00)