Retrofitting radio wiring harness - AZ82.60-P-0003-01PA

Connection schematic for radio 

Fig 1: Connection Schematic Diagram For Radio Wiring Harness

1. Route wiring harness (30) along present leads in vehicle as shown in figure.

   Connection schematic for radio 

   Fig 2: Connection Routing Diagram For Radio Wiring Harness

   
2. Route tie-out for wiring harness (30) to radio (A2) and connect to chamber C.
   Fig 3: Identifying Wiring Harness And Radio

   
3. Route wiring harness (30) in wiring duct in front of passenger seat as shown in figure.
   Fig 4: Identifying Radio, CD Changer, Voltage Distributor Connector And Wakeup Signal Connector

   
4. Clip wake-up signal connector (X30/8) to present connector package (see left figure section).

   The wake-up signal connector (X30/8) serves only as jumper for the individual blue/black (bl/sw) leads - the connector is not connected with the standard wiring harness.

5. Install tie-out to right potential distributor connector (CAN bus) (X30/4) to next free plug location.
   Fig 5: Identifying Wake-Up Signal Connector

   
6. Tie tie-out from wiring harness (30) to CD player with changer (A2/6) back behind radio (electrical pre-equipment for CD changer).
   Fig 6: Identifying CD Player With Changer Wiring Harness Tie-Out Routing