Retrofit MOST fiber optical cable wiring harness - AN82.61-P-0001-06P

Press engagement lug (arrow) of the ordered MOST wiring harness outward slightly and pull the black, 2-pin MOST coupling (14) out of the MOST connector housing (11).

Fig 1: Identifying 2-Pin MOST Coupling
Unclip blue retaining clip (15) out of the black, 2-pin MOST connector (14).
It must be ensured that the fiber optical cable module (8) in chamber 1 (input) is installed (see arrow). If this is not the case, install fiber optical cable module (8) from chamber 2 in chamber 1.

Fig 2: Identifying Retaining Clip And 2-Pin MOST Coupling
Press engagement lug (arrow) of the second ordered MOST wiring harness outward slightly and pull the black, 2-pin MOST coupling (13) out of the MOST connector housing (12).
The MOST connector housing (12) is no longer required.

Fig 3: Identifying MOST Coupling And Connector Housing
Unclip blue retaining clip (16) from the black, 2-pin MOST coupling (13).
It must be ensured that the fiber optical cable module (9) is installed in contact cavity 1 (input) (see arrow). If this is not the case, move fiber optical cable module (9) from contact cavity 2 to contact cavity 1.

Fig 4: Identifying Blue Retaining Clip And 2-Pin MOST Coupling

Fig 5: Identifying Fiber Optical Cable Module And MOST Connector Housing
Install fiber optical cable module (9) in contact cavity (2) (output) of black, 2-pin MOST coupling (14).
Fiber optical cable module (9) must latch audibly.
Install blue retaining clip (15) into the black, 2-pin MOST connector (14).
Clip the black, 2-pin MOST coupling (14) into MOST connector housing (11).
The MOST connector housing (11) will later be connected to the CD player with changer (in glove compartment).

Fig 6: Identifying Fiber Optical Cable Module And MOST Connector Housing
Install the fiber optical cable module (8) in contact cavity (2) (output) of black, 2-pin MOST coupling (13).
Fiber optical cable module (8) must latch audibly.
Install blue retaining clip (16) into the black, 2-pin MOST coupling (13).
Black, 2-pin MOST coupling (13) will be later connected to radio.
Wrap felt tapes (20, 21) on the MOST wiring harness at the locations shown in the illustration (note measurements).
1. = 75 mm
2. = 70 mm
3. = 140 mm
  
  Fig 7: Identifying Felt Tape On MOST Wiring Harness Area
  
  Fig 8: Identifying Fiber Optical Cable Modules With Black MOST Connector Housing
Route fiber optical cable modules (8, 9) with black MOST connector housing (11) from radio recess through the cutout into the glove compartment.
Risk of breakage! Do not kink optical waveguide, route over sharp edges or bend in radii smaller than 25 mm. Tensile forces on inserts must not exceed 65 N. Do not squeeze fiber optical cable and do not compress with clamps or tie straps.

Fig 9: Identifying 2-Pin MOST Coupling And 16-Pin Radio Coupling
Install black, 2-pin MOST coupling (13) into the black, 16-pin radio coupling (A2).
Risk of breakage! Do not kink optical waveguide, route over sharp edges or bend in radii smaller than 25 mm. Tensile forces on inserts must not exceed 65 N. Do not squeeze fiber optical cable and do not compress with clamps or tie straps.