Removing and installing folding rear backrest - AR91.12-P-1720P

MODEL 203.0 with CODE (287a) Through-loading feature 

Fig 1: Identifying Intermediate Pad And Intermediate Pad Screws

Fig 2: Identifying Folding Rear Backrest Remove/Install Components

Fig 3: Identifying Left Bearing Bolt And Bearing Bracket Nuts

	Removing, installing
1	Remove side upholstery		AR91.12-P-1710P
2	Unscrew screws (1) from intermediate pad (2)	Put down sealing felt.
3	Remove intermediate pad (2).
4	Unscrew screw (9)	Bolt on rear belt buckle	*BA91.40-P-1007-01A
		Torx bit set	Figure
5	Unscrew screws (3)	Screw for outer bearing bolt on wheelhouse	*BA91.12-P-1001-03C
		External torx set	Fig 5
6	Unscrew nuts (4)	Nut for inner bearing bracket on vehicle floor	*BA91.12-P-1003-03C
7	Release rear backrests (6, 7) and fold over
8	Unscrew nuts (4)	Nut for inner bearing bracket on vehicle floor	*BA91.12-P-1003-03C
9	Disconnect pneumatic connection (5)
10	Remove 1/3 rear backrest (6)
11	Disconnect pneumatic connection (5)
12	Remove 2/3 rear backrest (7)	Lift off of bearing bracket and pull 2/3 rear backrest (7) off of left bearing bolt (8).
13	Install in the reverse order

REAR SEATS

Number	Designation		Model 203
BA91.12-P-1001-03C	Screw for outer bearing bolt on wheelhouse	Nm	23
BA91.12-P-1003-03C	Nut for inner bearing bracket on vehicle floor	Nm	40

SEATBELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 203
BA91.40-P-1007-01A	Bolt on rear belt buckle	Nm	30

Fig 4: Identifying Torx Bit Set (000 589 01 10 00)

Fig 5: Identifying External Torx Set (001 589 76 09 00)